It also has a signal light on it, which is normally lit up if all is working. '239' is '17'.) But my CASA brand laser works fine on the DMX King, no response on the udmx. Especially seeing as the dmx table for the lights is opposite. I've swapped cables, lights, usb lead, etc. Interestingly, if I select all channels at 100%, it will happily broadcast all 512 channels constantly, no flickering at all. Anything over and it appears to bounce between no signal and the value (also shown by flickering cursor in dmxKing config). Ie, if it has 2 lights with dipswitches '3' and '112' it will go from the '3'. I've been playing around with the DMXKing one today and have worked out from the DMX King config program (yes I have been using it to troubleshoot) that it works fine as it only outputs precisely 255 channels from the first (as in numerically) lights address. After the timing, is is nearly always cables. * a bad fixture with a dry joint or forced connection.
* more than 36 or so fixtures in a single line without an isolator or amplifier between them. * lack of proper 120 ohm resistor at the end of run (last fixture) can cause a wired echo type thing which causes interference in the line. * cables coiled up trying to be neat nearby a mains cable (or mains cable is coiled even worse).
* cables tangled or twisted around mains cables, or other sources of interference. * microphone cable used in place of dmx cable (although you can sometimes get away with it if you only use a dozen or less fixtures).
If this works fine then any further issues are with cabling and are usually caused by one of the following issues When all your fixtures/channels are being output from freestyler start with only one actual fixture plugged in. I would also point out though that dmxking provide a configuration utility (download from here ) and once you select the virtual comport you are using the second tab allows you to select from some timing presets already created for you, and there is one there that works very well called something like 'maximum compatibility' or something like that you can send to the device that just seems to work with about anything and still keep a good 40Hz frame rate.Īlso from experience, never use a usb extension cable on a usb-dmx controller, they seem to lose frame rate or worse have communication issues that can sometimes be intermittent (but you can have a massive dmx cable coming off other end with no problems though). And I normally run 5 moving heads, 10 scanners, 12 LED parcans, a pair of miracled's, a pair of big Martin barrel effects, and other all at the same time!
#UDMX FLICKERING PRO#
Normally these things are a case of following sequence it gives you carefully (such as copying file at time listed and not at end of installation sequence).Īlthough I use the dmxking ultradmx pro micro, and that has never had a problem with either freestyler, or a whole variety of lights I have used with it.
#UDMX FLICKERING MANUAL#
The instructions, including a manual copy of files after they are uncompressed, is all in the advert you linked.
0 kommentar(er)
